Skip to main content

Bracelets Size guide

Measuring Your Wrist


1) Use a tape measure, or if you do not have one, use a strip of paper, ribbon or cord. Wrap it around your wrist where you would normally wear the bracelet.

2) If you are using a strip of paper, ribbon or cord. Mark the end of the strip and then measure the length against a ruler. This is your wrist size.


Chain Bracelets:

Measure your wrist circumference using a flexible measuring tape or a string. Add approximately ½ inch to 1 inch (1.27 to 2.54 cm) to the measured size for a comfortable fit.


Bangle Bracelets:

Measure the widest part of your hand, typically around the knuckles, with your fingers extended and close together. Add approximately ½ inch (1.27 cm) to your hand measurement to determine the appropriate bangle size. This extra length allows the bangle to slide over your hand and fit comfortably on your wrist.

Cuff Bracelets:

Measure the circumference of your wrist with a measuring tape or string, making sure it's snug but not too tight. This measurement will be your cuff size.